Hi all, I've been trying to configure the SpeedFan module of Sysstats to show my CPU temperature.
I have it set up correctly (I think). It shows the Temperature, but ONLY if I manually click Update.
If I leave it running it stays at the temperature it was the last time I clicked update.
I have played with the interval setting, but to no avail. Am I doing anything wrong?
bump
I'm not familiar with Speedfan, but most other meters have an option to set an update interval.
Look in the docklet's configuration->meters page & highlight the most likely meter to be the one you're interested in. If you can enter an update interval (say 1sec or 5 sec) do so, then OK & save the config.
It sometimes also helps to re-load the config after saving.
HTH.
Aqua-Soft Forums